|
|
|
7
Reasons
for Buying from Bay City Hot Tubs |
24
Years of Experience and Knowledge
We've been custom-building
high-performance top quality hot tubs since 1982.
No Middlemen—We Sell
Direct
Saving Customers $1,000 to $3,000 on every
new hot tub purchase.
Commitment To Our Customers
We have over 10,000 highly satisfied
customers in all parts of the United States.
"Platon"
Waterproofing
The bottom of every Bay City Hot Tub is
covered with "Platon", a 24-mil. high density
polyethylene waterproofing membrane. Most hot tubs
leave the bottom of the tub unprotected, allowing for
mildew and rotting. The dimpled design of the Platon
membrane creates an air space that promotes a dry,
high-efficiency bottom exterior.
A Good Life Spas Exclusive!
Exclusive Dual-Source Heat
Technology
Our
exclusive Dual Source Heat System uses radiant
heat transfer technology to transfer heat energy from
the electric pump motors to the hot tub’s water to
provide up to 80% of the heat energy needed to heat the
water in the hot tub. This system is augmented by a 5.5 kw,
thermostatically controlled, electric heater to supplement
the “free” heat provided by the radiant transfer.
Heats the water for 30% less than conventional hot tub
heat systems. A Good
Life Spas Exclusive!
Aluminum Radiant Barrier:
Aircraft Tested, Easy Service
The aluminum Radiant Barrier insulation in
Bay City Hot Tubs is the highest efficiency in the hot tub
industry. It is the same type of insulation used in
high altitude jet aircraft, which operate in a
50-degree-below-zero environment. This insulation is
also installed in a way that allows for easy service in
the unlikely event of a plumbing leak.
A Good Life Spas Exclusive!
Warning:
do not purchase any hot tub that uses
"full foam" insulation. Full foam
insulation makes it nearly impossible to work on the
plumbing in case of a leak, and leaks are more likely
after several years' use when the hot tub is most likely
out of warranty. Repairing a leak in a "full
foam" spa can cost up to $3,000!
Made-In-The-USA
Quality!
All
of the components used to build our hot tubs are
manufactured in the USA by top rated manufacturers like
Aqua Flo, Tecmark, Hydro Air, Pentair, Waterways, O’Ryan,
Allied Innovations, and Lasco Fittings.
These manufacturers
Back
their products with solid warranties that allow us to
provide you with Award
Winning Service that
is top rated in our industry.
|
|
Copyright 1998-2008 Good Life Spas, Inc.
|
